The new hydraulic oil press does not feed and jams, especially for new customers, temporarily unable to find the reasons and treatment methods for the new hydraulic oil press not to feed
The screw shaft of the new hydraulic oil press suddenly jams: the feed is too fast and the load increases suddenly; it stops immediately and pours out the cake residue in the press chamber.
Uneven steaming in the pot: During inspection, if the steam hole is blocked or corroded, the steam hole should be cleared; if the billet sticks to the bottom of the pot in the middle and lower pot, the distance between the scraper and the bottom of the pot can be adjusted;
If the scraper is twisted and worn, the scraper should be replaced; if the blank is not evenly steamed, the limit switch, contact and floating plate should be adjusted to coordinate their actions.
Belt oil does not extract material: The lower part of the bucket elevator conveyor accumulates too much oil and is blocked. Open the door at the lower part of the conveyor to remove the accumulated oil.
The sieve cloth oil goes on one side: During inspection, if the screen surface is not level, adjust the length of the left and right booms to make them equal; if the screen body twists and swings, you can adjust the eccentric wheel shaft to make it perpendicular to the frame.
The oil has many hard crusts and is dry, and the resistance is large; the gap of the cake outlet is too small, and the cake ring is not smooth. Fourth, the body temperature is low. The hard objects enter the squeeze tank with the oil to remove the hard shell and adjust the moisture of the oil.
Adjust the gap between the cake openings and grind the cake rings clean to increase the body temperature. Fifth, take out the hard things and cake residues from the squeezer.