Are you looking for oil extracting machines supplier?Wonder industries ltd., Has More Than 15 year's Professional Experience In The oil extracting machines manufacturing To Suit All Your Needs.Get Instant Quote:[email protected]com .

Problems to be paid attention to when operating the small oil press

Problems to be paid attention to when operating the small oil press

Only by mastering certain skills in the operation and processing of the small oil press can the oil extraction rate be improved. However, if the various machinery in the combined equipment fails to be eliminated in time, it will also affect the oil extraction capacity, but don’t worry, users can eliminate it according to the following methods:

  • 1. The belt is lubricated without material lifting. The main reason is that too much oil accumulates in the lower part of the conveyor of the bucket elevator, causing blockage. You can open the plate door at the lower part of the conveyor to remove the accumulated oil.
  • 2. The sieve cloth oil is taken unilaterally. During inspection, if the screen surface is not horizontal, the length of the left and right booms should be adjusted to make them equal; if the screen body is twisted, the eccentric wheel shaft can be adjusted to make it vertical to the frame. If the oil on the screen surface is removed from the stone, the frame can be adjusted to make it level; if the air flow is uneven, the air box of the air box can be adjusted to make the air flow evenly blow to the screen surface. If the sieving rate is low, the brush should be replaced or the length of the brush should be adjusted, and the tilt angle of the flat screen should be adjusted at the same time.
  • 3. The roll does not rotate when overloaded. The troubleshooting method is: if there is oil between the rolls when starting, loosen the roll adjustment bolts to remove the oil between the rolls; if the feeding amount is too large and the speed is too fast, you can close the inserting plate at the unloading port; if it is rolling If the thickness of the blank is uneven, the roll gap should be readjusted and the loose nut should be tightened.
  • 4. Uneven steaming on the pot. When checking the oil press, if the steam injection hole of the steamer is blocked or rusted, the steam injection hole should be cleared. If the blank is pasting the bottom of the pot in the middle and lower pot, the distance between the scraper and the bottom of the pot can be adjusted; if the scraper is twisted and worn, the scraper should be replaced; if the blank is steamed and cooked unevenly, the limit switch should be adjusted, Contacts and floating plates to coordinate their movements.

The above four points are provided by the oil press manufacturer, and hope to help the majority of users.

 
Comments

No comments yet.